This allows you to check an angle across the diagonal of the room, or the partial diagonal.
Step 1: Click Check, and then click Check Angle.
Step 2: In the floor plan, select Check Angle.
Step 3: Use the multiple measurement function on the Disto to measure the maximum distance between the walls where the angle is located.
Step 4: Manually enter the maximum value of the diagonal displayed on the Disto next to max in the Diagonal field and the new angle value will be calculated automatically.
Step 5: Finish the command with the Blue Check mark in the upper right corner. The floor plan is automatically redrawn with the new angle.
You can also measure the partial diagonal if the diagonal cannot be measured.
Step 1: and Step 2: as above.
Step 3:
1 Activate the field to the right of the 4' and then measure the value of the partial wall length 4'. Transfer the value from the disto to the field.
2 Then the field 1' is automatically activated and you can measure and transfer the partial wall length 1'.
3 The Diagonal field is then automatically activated. Measure the maximum length of the partial diagonal with the multiple measurement function on the laser.
Step 4: Manually enter the maximum value of the diagonal displayed on the Disto next to max in the Diagonal field and the new angle value will be calculated automatically.
Step 5: Finish the command with the Blue Check mark in the upper right corner.
The floor plan is automatically redrawn with the new angle.
