< previous page next page >

In this way, you can check or change objects that have already been measured, e.g. doors, windows, radiators or obstacles.

You have the option to check an object in the floor plan view:

OR you switch to a wall view to check: Click Sheets and, select the wall view where the component you want to check is located.

Step 1: Select Check.

Step 2: Select Check object.

Step 3:

Select the object to be checked in the view, in this example obstacle 1 on wall 4.

Step 4: Now check all the values you want to change: For example, re-measure the depth of the therme and transfer the measured value to the Depth field. Afterwards, for example, you can also re-measure the upper height of the therme.

Step 5: End the command with the blue check mark in the upper right corner.

ATTENTION:

After that, you must select Prozess walls. This will redraw the changed values in the wall view.

Step 6: Click on Prozess walls.

Afterwards the changes are shown in the wall view:

In the text stamp for obstacle 1 you can see the new values for the

Width W: 600

Height H: 1100

Depth D: 600

Front Edge FE: 600

Top Edge TE: 1400

< previous page next page >

Did this answer your question?