How to insert an obstacle (e.g. a boiler).
Step 1: Select Obstacles.
Step 2: In the floor plan, select the wall corner from which you measure the obstacle.
Step 3: Measure the values with the laser in order and transfer the respective measured value from the laser to the corresponding input field with the Bluetooth key after each measurement. After each transfer, the next field is active.
Measure the distance d1.
Measure the width.
Measure the depth, front edge obstacle to the wall.
Measure the top height, top edge of the obstacle to the floor.
Measure the bottom height, bottom edge of the obstacle to the floor.
Measure the distance to the wall, if the depth has already been measured to the wall, the distance to the wall is 0.
Enter other important information about the obstacle in the comment field;
e.g. Gas boiler.
Step 4: Add the measured radiator to your floor plan with the Blue Check mark in the upper right corner.
Step 5: Exit the Measure radiator command with the White Cross in the upper right corner.
